user manual

Table 3-29 Jetdirect Menu (continued)
First level Second level Third level Fourth level Fifth level Values Description
Link Speed Auto* The link speed
and
communication
mode of the print
server must match
the network. The
available settings
depend on the
product and
installed print
server. Select one
of the following
link configuration
settings:
CAUTION: If
you change the
link setting,
network
communications
with the print
server and
network product
might be lost.
Auto*
The print server
uses auto-
negotiation to
configure itself
with the highest
link speed and
communication
mode allowed. If
auto-negotiation
fails, either
100TX Half or
10T Half is set
depending on the
detected link
speed of the hub/
switch port. (A
1000T half-duplex
selection is not
supported.)
10T Half 10T Half
10 Mbps, half-
duplex operation.
10T Full 10T Full
10 Mbps, full-
duplex operation.
ENWW
Tools for troubleshooting
381