user manual

5. Disconnect one connector (callout 1), remove two screws (callout 2), and then carefully lift the
assembly (callout 3) off of the product to remove it.
CAUTION: A solenoid arm (duplex models only; on the right side) and a spring (on the left
side) on the assembly are not captive. Do not lose the solenoid arm or spring when you remove
the assembly. If the solenoid arm or spring become dislodged, see
Reinstall the delivery assembly
on page 232.
Figure 2-228 Remove the delivery assembly (5 of 5)
1
3
2
ENWW
Internal assemblies
231