user manual

Fuser drive assembly
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner collection unit on page 79.
●
Formatter. See
Formatter PCA on page 81.
●
Fuser. See
Fuser on page 87.
●
Secondary transfer assembly. See
Secondary transfer assembly on page 96.
●
Right rear cover. See
Right rear cover on page 109.
●
Left cover. See
Left cover on page 111.
●
Hardware integration pocket (HIP). See
Hardware integration pocket (HIP) (dn and xh models
only) on page 115.
●
Control panel assembly. See
Control panel assembly on page 116.
●
Front top cover. See
Front top cover on page 122.
●
Rear cover and upper rear cover. See
Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the
fuser drive assembly.
●
Rear top cover. See
Rear top cover on page 127.
●
Power supply fan and fan duct. See
Power supply fan and fan duct on page 147.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 158.
●
DC controller PCA. See
DC controller PCA and tray on page 160.
●
Low voltage power supply. See
Low voltage power supply on page 163.
●
High voltage power supply lower. See
High voltage power supply lower (HVPS-D) on page 167.
●
High voltage power supply upper. See
High voltage power supply upper (HVPS-T) on page 201.
●
Main drive assembly. See
Main drive assembly on page 212.
ENWW
Internal assemblies
223