user manual

Cassette pickup assembly
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner collection unit on page 79.
●
Formatter. See
Formatter PCA on page 81.
●
Secondary transfer unit. See
Secondary transfer assembly on page 96.
●
Intermediate transfer belt. See
Intermediate transfer belt (ITB) on page 98.
●
Right rear cover. See
Right rear cover on page 109.
●
Left cover. See
Left cover on page 111.
●
Rear cover and upper rear cover. See
Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the
cassette pickup assembly.
●
Registration density (RD) sensor assembly. See
Registration density (RD) sensor assembly
on page 143.
●
Power supply fan and fan duct. See
Power supply fan and fan duct on page 147.
●
Registration assembly. See
Registration assembly on page 150.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 158.
●
Low voltage power supply. See
Low voltage power supply on page 163.
●
High voltage power supply lower. See
High voltage power supply lower (HVPS-D) on page 167.
●
Cassette pickup drive assembly. See
Cassette pickup drive assembly on page 176.
ENWW
Internal assemblies
183