user manual

Lifter drive assembly

Before proceeding, remove the following components:

●

Toner collection unit. See

Toner collection unit on page 79.

●

Formatter. See

Formatter PCA on page 81.

●

Right rear cover. See

Right rear cover on page 109.

●

Left cover. See

Left cover on page 111.

●

Rear cover and upper rear cover. See

Rear cover and upper rear cover on page 124.

NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the

lifter drive assembly.

●

Interconnect board (ICB). See

Interconnect board (ICB) on page 158.

●

Low voltage power supply. See

Low voltage power supply on page 163.

●

High voltage power supply lower. See

High voltage power supply lower (HVPS-D) on page 167.

Remove the lifter drive assembly

1. Disconnect eight connectors (callout 1), and then release the wire harness from the retainers.

Figure 2-147 Remove the lifter drive assembly (1 of 2)

ENWW

Internal assemblies

173