user manual

Tray-pickup drive assembly
Before proceeding, remove the following components:
●
Formatter. See
Formatter PCA on page 78.
●
Upper-left cover. See
Upper-left cover on page 96.
●
Power-supply cover. See
Power-supply cover on page 98.
●
Left cover. See
Left cover on page 99.
●
Front-top cover. See
Front-top cover on page 100.
●
Rear-top cover. See
Rear-top cover on page 102.
●
Right-front cover. See
Right-front cover on page 103.
●
Rear cover. See
Rear cover on page 112.
●
Right-rear cover. See
Right-rear cover on page 110.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 153.
●
Low-voltage power supply. See
Low-voltage power supply (LVPS) on page 157.
●
High-voltage power supply lower. See
High-voltage power supply lower (HVPS-D) on page 163.
Remove the tray-pickup drive assembly
NOTE: To remove the pickup motor only, see Pickup motor on page 172.
1. Release two tabs, and then remove the power-supply fan.
Figure 2-161 Remove the tray-pickup drive assembly (1 of 3)
178 Chapter 2 Removal and replacement ENWW