Operation Manual

1
Please follow the instructions to make sure that you get the
most from your timer for simple and efficient watering.
INSTALLING THE BATTERIES
You must
use Alkaline batteries: Alternatives will result in
incorrect operation.
i. Remove screws and back cover
ii. Insert two 1.5V ‘C’ Alkaline batteries. (Check + and – are
correct).
iii. Ensure rubber seal is positioned correctly; failure to do so
will break the waterproof seal and may cause the Water
computer to fail.
iv. Replace back cover and screw down tightly. Repeat steps iii
& iv every time the back cover is removed.
CONNECTING THE WATER COMPUTER TO THE TAP. (FIG.3/4)
i. Choose the correct tap adapter for your tap. The largest size
(part 3) is permanently fitted to the Water computer. Part 1
screws into part 2. Part 2 screws in to part 3.
ii. With the correct adapters in place, hold the Water computer
up to the tap. Tighten firmly to avoid leaks.
SETTING LANGUAGE AND TIME
i. Select your language using the and buttons and press
.
ii. Select the day by using the and buttons and press .
Repeat to set the hour and minutes, pressing each time.
iii. Press if you are happy with the settings, if not, you can
go back to make changes ( ).
MANUAL OPERATION
This will operate watering immediately, without using any
programs. It will override any active programs.
1 1/2 Inch adaptor
2 3/4 Inch adaptor
3 1 Inch Adaptor (fitted)
4 Battery level
5 Current time
6 Watering program overview
7 Today’s watering programs (if set)
8 Watering mode
9 Left button screen prompt
10 Right button screen prompt
11 Left button (red)
12 Right button (green)
13 Up button (blue)
14 Down Button (blue)
15 Hose pipe connector
GB
IMPORTANT: RECHARGEABLE BATTERIES MUST NOT BE USED.
REPLACE BATTERIES EACH SEASON. (MAX 12 MONTHS USE).
PROTECT YOUR WATER TIMER FROM FROST. REMOVE FROM
THE TAP IN WINTER. PRODUCT NOT GUARANTEED AGAINST
FROST DAMAGE. REMOVE BATTERIES WHEN NOT IN USE.