Operation Manual
2
Pressure Reducer
Reduces water pressure delivered from the mains tap to your
system, to ensure optimal performance. An integrated filter
prevents dirty water affecting dripper performance.
Connect the Pressure Regulator to the hose using one of the
methods below:
•AttachtheSupplyTubeusingthe13mmadaptor.
•Replacethe13mmadaptorwitha4mmadaptorandpush
the Micro Tube through the centre.
i
ii
2
13mm
i ii iii
4mm
2
B - Pipeline
Pipeline
This can be cut and adapted to create your ideal watering
system layout. It efficiently carries water from the main
supply and delivers it to your plants via a network of drippers.
3
Supply Tube
A large 13mm tube used to transport water around medium
to large systems. Create the network using Elbows (5),
T-Connectors (6), Straight Connectors (12) and End Plugs (7).
Secure in place using Stakes (8) and Wall clips (10).
Note: No one length of Supply Tube should be more than
25m long, or 50m if run in a ring back to the tap.
i ii iii
5
13mm
i ii iii
6
13mm
i ii iii
7
13mm
i ii iii
8
13mm
i ii iii
10
13mm
i ii iii
12
4mm13 m m
4
Micro Tube
A small flexible 4mm tube used to transport water around
small systems, or to take water from the Supply Tube to the
plants in larger systems. Connect to the Supply Tube using a
Straight Connector (12) or split the flow using a T-Connector
(11). Secure in place using Wall Clips (13).
Note: No one length of Micro Tube should be more than
15m long.
i ii iii
4mm
11
i
ii iii
4mm
12
i ii iii
4mm
13
14
Hole Punch
Use to make holes in the Supply Tube for accessories and for
joints with the Micro Tube. Use hexagonal slot in the back of
the hole punch to tighten the drippers into the tube and to
remove them. Seal unwanted holes with Blanking Plugs (9).
i
ii
iii
14
4mm13 m m
i ii iii
9
13mm