Operation Manual

7
Battery Level Check
(Press And Hold Down The Water Now
Button)
3x Green Lights Battery level is Excellent
2x Green Lights Battery level is Good
1x Green Light Battery level is ok but consider replacing
them soon
1x Red Light Battery level is low - replace the batteries
now
Failure prevention mode
A built in safety feature detects when the battery levels have
dropped to a level that could fail whilst the valve is open and result
in wasting water. The safety mode prevents the controller from
turning on until the batteries have been replaced. The LED indicator
light will flash red when the failure prevention mode has been
activated. The Water Now function will also not operate until the
batteries have been replaced.
This product is not designed to be used in sub-zero (frost)
temperatures. During winter months drain any remaining
water out of your timer and bring it indoors until the next
watering season.
Troubleshooting
Problem Possible cause Solution
Valve opens but no
water comes out
Garden tap is off Turn on tap
Hose pipe twisted or
blocked
Untwist/unblock
hose hose
Button pressed but
valve doesn’t open
Wrong or flat
batteries
Check battery type
and/or replace with
fresh batteries
Button pressed
Light came on but
valve did not open
1 minute lock out
has operated
Wait three minutes
and try again
Controller set up
correctly but did not
come on at sunset
Controller waiting
to synchronise
Wait 24hrs and
observe again
Controller activated
when outside lights
come on
Outside lights too
bright
Move or rotate
controller away
from light sources
Technical Data
Operating Pressure 0.1 – 10 Bar
Operating Temperature 0 - 55°C
Max. Water Temperature 30°C