User Guide

length indicator arrow on the cam aligns with the

desired draw length scribed on the module (Figure

21). Reinstall both screws and re-tighten. Note that

at draw lengths between 18 and 22 inches the lower

fastening screw location will be utilized (Figure 21),

while draw between 23 and 26 inches utilize the

upper module fastening screw location (Figure 22).

Always be sure to install and tighten both module

screws prior to drawing or shooting the bow to pre-

vent damage to the product.

After the bottom cam draw length is adjusted, repeat

the procedure on the top wheel by loosening the fas-

tening screw and removing the draw length screw.

Rotate the module to the SAME draw length position

as the bottom module and replace and tighten both

BOTTOM CAM SET AT 25” DRAW

fig 22

Bowstring

Control Cable

Buss Cable

Control Cable Peg

Fastening Screw

(Upper Location)

Draw Length Screw

Draw Length

Indicator Arrow