User Guide

WHEEL & 1/2 OPTIONAL DRAW STOP

The draw stop on the Wheel & 1/2 system can be uti-

lized to customize the feel of the back wall. If you

prefer a hard wall, install the peg in the threaded 6-

32 hole in the bottom cam as shown in Figure 19. If

you prefer a softer wall and more of a "valley," shoot

the wheel without the draw stop installed. The use of

any non-Hoyt draw stop will void the product war-

ranty and may damage the product.

VERSA CAM & 1/2 DRAW LENGTH ADJUSTMENT

Hoyt’s youth cam, the Versa Cam & 1/2 System, fea-

tures a patented inner-cam draw length adjustment

that does not require the use of a bow press. To

adjust the draw length, start by removing the draw

length screw and the module fastening screw from

the bottom cam. Rotate the module until the draw

BOTTOM CAM SET AT 20” DRAW

Bowstring

Control Cable

Buss Cable

fig 21

Control Cable Peg

Draw Length Screw

Draw Length Indicator Arrow

Fastening Screw

(Lower Location)