User Guide

draw length screw first and then the fastening

screw.

BOTTOM CAM: Remove the draw length screw,

rotate module to the same lettered position as the

top module,

and re p l a c e .

(see fig 12)

Note: Yo u

must make the

same adjust-

ments to the

top and the

bottom inner-

cams or the

bow will not

tune properly.

WARNING: Never remove the stainless steel

control cable peg unless the string is relaxed in

a bow press.

OPTIMIZING CAM & 1/2 PERFORMANCE

In order to verify the factory setting of your

adjustable Cam & 1/2 System bow you should

examine the cam's built-in re f e ren ce holes. When

viewing the module side of the t o p cam, at least

part of the control cable should lie over the re f e r-

ence hole (see fig13). When viewing the module

side of the b o t t o m cam, at least part of the buss

fig 12

BOTTOM CAM

Draw

Length

Screw

Module Positioning

Indicator

Control

Cable

Peg