User Guide

OPTIMIZING CAM & 1/2 PERFORMANCE

In order to verify the factory setting of your Cam &

1/2 System bow you should examine the cam's

built-in reference holes. When viewing the module

side of the top

cam, at least part of the control cable

should lie over the reference hole (see fig14). When

viewing the module side of the bottom

cam, at least

part of the buss cable should lie over the reference

hole as shown

in fig 15. It is

not necessary

to have the

cables exactly

centered over

the reference

holes. Module

position will

not affect the

reference hole

location.

Bowstring

Buss Cable

Yoke

Control

Cable

Reference

Hole

Reference

Hole

fig 14

fig 15

TOP CAM

BOTTOM

CAM

Bowstring

Buss

Cable

Control

Cable

Reference

Hole