User Guide

12
After the bar has been inserted fasten with the
1/4-20 x 1/2” set screws provided. (See fig 6)
CABLE GUARD GLIDE INSTALLATION
To prevent your bow’s cables from rubbing
against each other, Hoyt USA uses a specially
designed cable glide that has
off-set cable slots. To correctly
install the glide on all Hoyt
bows, first place the glide on
the cable guard bar. (See fig 7)
Next, push the control cable
into the shorter front slot.
Then, push the buss cable into
the longer rear slot.
CAUTION: Do not pull bow
back without proper installation of cable guard
bar and glide.
TILLER ADJUSTMENT
Tiller is the difference in distance between the
upper limb to the string and lower limb to the
string measured from the base of the limbs
(where the limb and riser meet) at a 90 degree
angle to the string. (See fig 8)
The main function of tiller is to allow the archer to
more easily and comfortably aim during the draw
and release of the shot. Most bows will shoot best
fig 7
Control
Cable
Buss
Cable