User Guide

between the marks. (see fig 15) It is not necessary to

have the limb exactly centered between the marks.

Your new bow was shipped from our factory in the

optimum position. If your limb lies outside the per-

formance marks we recommend you take your bow

to your Hoyt Pro Shop for adjustments.

The let-off of your Spiral Cam & 1/2 bow can be

adjusted using a standard allen key. The AMO

let-off values of the Spiral Cam & 1/2 vary from

55% to 65%. You will notice the four draw-stop

holes on the bottom cam numbered 1 through 4.

(see fig 16) For 55% let-off, the draw-stop peg

should be placed in

hole #4. Simply

remove the draw-

stop peg from its

original position,

place it in the

desired position,

and tighten. Each

Hoyt Spiral Cam &

1/2 bow was

shipped in the 65%

let-off (draw stop

peg position #1).

Note: changing the draw-stop position to manipu-

late let-off will alter draw length by approximately

1/8” for each draw-stop hole; draw length will be

shortened when changing to a lower let-off position

and lengthened in higher let-off positions.

CABLE

SIDE

fig 16

Draw Stop in Highest Let-off Position