User Guide

12
mounting hole. After the bar has been inserted
fasten with the 1/4-20 x 1/2” set screws provid-
ed. (See fig 6)
Hoyt USA’s magnesium bows are designed with
a high mount style cable guard bar that is
mounted directly to the side of the riser by two
10-24 screws. (See fig 7) Prior to mounting the
cable guard bar, you must remove the rubber-
bands used only for shipping purposes.
Warning! On
some shorter
axle to axle
models,
adjustable cable
guard bars can
be off-set too
much causing
the cable to
track off the
cam. This can
cause damage to the bow or personal injury. To
prevent this from happening, NEVER SET THE
BAR AT THE THREE O’ CLOCK POSITION.
CABLE GUARD GLIDE INSTALLATION
To prevent your bow’s cables from rubbing
against each other, Hoyt USA uses a specially
designed cable glide that has off-set cable slots.
fig 7
10-24 SHCS
Screws