User Guide

10
position the nock set just above level. A finger
shooter should initially position the nock set at
approximately 3/8” above level. The release
shooter should begin at approximately 1/4”
above level. (See fig 4) Once the nock set is at
the desired location use a special set of nocking
pliers to crimp the nock set into place. NEVER
shoot a bow without a nock set or with a nock
set that has not been properly crimped. For
proper installation Hoyt USArecommends that
this be done by a qualified Pro Shop.
fig 4
CABLE GUARD INSTALLATION
Some Hoyt USA bows use a high or low mount
style cable guard bar that is mounted directly to
the side of the riser by two 10-24 screws. (See
fig 5)
Some models use an adjustable cable guard bar
that is inserted into a bushing in the riser. This
type of cable guard bar is installed by inserting
the bar into the bushing and securing it with
two small set screws. (See fig 6)