User's Manual

Microinverter user manual
11
required by local jurisdictions.
Step 3. Connect AC Cables of Microinverter
a. Plug the AC connector of the first microinverter into the connector of
the next microinverter, and so forth, to form a continuous AC branch
circuit
b. Install the AC End Cap on the open AC connector of the last
microinverter in the AC branch circuit
Step 4. Connect AC End Cable
a. Connect the AC End Cable connector to the adjacent microinverter
connector.
b. Connect AC End Cable to the junction box and wire with the cable to
the electricity network. Close the junction box after the wiring is
complete.
Note： Red Wire: L1
Black Wire: L2
Yellow/Green Wire: Ground
Step 5. Create an Installation Map
a. Peel the removable serial number label from each microinverter. The
position of the label is shown as below.