Manual

J1J1
LED5LED5
LED6LED6
LED4LED4
LED3LED3
LED2LED2
LED1LED1
J2J2
IC2IC2
021-650SE ISSUE 1021-650SE ISSUE 1
LABELLABEL
CONTROLCONTROL
PRODUC
TION
PRODUC
TION
HEDHED
CC
BB
AA
DC POWERDC POWER DC POWERDC POWER
RELAY 1RELAY 1RELAY 2RELAY 2RELAY 3RELAY 3RELAY 4RELAY 4
RELAY 6RELAY 6RELAY 5RELAY 5
REMOTE INDICATIONSREMOTE INDICATIONS
12 +VE12 +VE F INPUTSF INPUTS R INPUTSR INPUTS D INPUTSD INPUTS
CCDDSSXX
--------++++++++
GN4GN4
GN3GN3
GN2GN2
GN1GN1
RD4RD4
RD3RD3
RD2RD2
RD1RD1
++
++
++
++
F4F4
F3F3
F2F2
F1F1
D4D4
R4R4
D3D3
R3R3
D2D2
R2R2
R1R1
D1D1 NCNC
COMCOM
NONO
NCNC
COMCOM
NONO
NCNC
COMCOM
NONO
NCNC
COMCOM
NONO
NCNC
COMCOM
NONO
NCNC
COMCOM
NONO
NCNC
COMCOM
NONO
NONO
COMCOM
NCNC
NCNC NONOCOMCOMNCNC NONOCOMCOMNCNC NONOCOMCOMNONOCOMCOMNCNC
Setting up Dwell and DOTL (Door Open Too Long) times.
To set up the dwell time. Move J1 to the B position and momentarily press button C to scroll through
the options. Each press will illuminate 1 of the 4 leds, numbered LED1 to LED4.
LED1 Follow the RTR (zero dwell time) Note this will not indicate breach if held on.
LED2 5 seconds (The default time)
LED3 10 seconds
LED4 20 seconds
To set up the DOTL time. Move J2 to the B position and momentarily press button C to scroll through
the options. Each press will illuminate 1 of the 4 leds, numbered LED1 to LED4.
LED1 20 seconds
LED2 60 seconds (The default time)
LED3 10 minutes
LED4 DOTL switched off (no time restraint for leaving doors open)
The times indicated when the jumpers are returned to the same position (either A or B) will be the
stored and used as the Dwell and DOTL times.
Note each jumper must be used independently.
Breach 1 Breach 2
Page 10