User's Manual

It contains Parking(parking time setting), L-Warn(low-speed warning), L-ALM(low-speed alarm),

H-Warn(high-speed warning), H-ALM(high-speed alarm), Spd Up(speed up) ,Spd Down(speed down)

these seven items.

Set the parameters refer to the following text. When it break the rule ,it will trigger an alarm.

For example , L-ALM(low-speed alarm), set it ON and the Limit value and other settings. If the vehicle

run a speed lower than the Limit value , it will trigger the alarm.

Enable: Press【Enter】to select: On / Off.

Limit: Set a speed value for system judgement.

Delay:Linkage‟s duration time. Press number keys to set. During this period, it will not response the

new alarm if there is a continuous triggering.

Wait: The waiting time in case of mistaken judgement or just wait.Press number keys to set.

Record: Turn on/off recording function.Press【Enter】to select: On / Off.

Alarm link: Press【Enter】key to select: OFF / Output 1 / Output 2/Buzzer.

Speed Source: Press【Enter】to select: GPS / Vehicle / Mix.

Pulse: Access through SPEED-A, SPEED-B operator to take the pulse factor. This function need an

external pulse sensor device.

Speed unit: km/h, MPH, nm/h for option.

For Parking, the Limit is also speed, you need set a speed first, if the vehicle under this speed, the

device will deem it‟s parking.

For speed up/down, set a value for it. If the vehicle harsh-accelerate or harsh-brake, the system will

compare the current speed with the previous second‟s speed all the time. If the change value more than

the setting parameter, It will trigger an alarm.

9.2.5.3. Acceleration