User's Manual

32
Delay: The alarm duration time after trigger source is removed, it is used for setting linkage‟s duration
time. During this period, it will not response the new alarm if there is a continuous triggering on the I/O
port.
Wait: The waiting time for trigger in case of mistaken touch.
Record: Press【Enter】 to select: On / Off, enable when the alarm happens, it will record or not.
Linkage: Press【Enter】to select: OFF/Output 1 / Output 2 / Buzzer/snap-up.
Output1:Output1 cable will output a DC12V voltage when alarm is triggered.
Output2:Output2 cable will output a DC12V voltage when alarm is triggered.
Buzzer:Need PCB support this component.
Snap-up: It will capture the picture while alarm is triggering . And save in the SD/HDD.
Preview: Press【Enter】to select the channel. When the alarms happen, it will pop-up the setting
channel „s image on the TFT screen .
For Linkage
RECORD: ON.
REC_LOCK: The alarm files will be locked in case of been deleted.
ALARM OUT: Choose output1, output2.
SNAPPIC: Take a snapshot. The picture will be saved in the device storage.
PRECHN: Preview channel when the alarm is triggered.
9.2.5.2. Speed Alarm