MSDS
MATERIAL SAFETY DATA SHEET
Butcher Block & Cutting Board Oil MSDS DATE: 06/16/11
PAGE 2 OF 3
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
PERSONAL PROTECTIVE EQUIPMENT
Eye/Face Protection: No special eye protection is normally required. Where splashing is possible, wear safety glasses with side shields
as a good safety practice.
Skin Protection: No special protective clothing is normally required. Where splashing is possible, select protective clothing
depending on operations conducted, physical requirements and other substances in the workplace. Suggested
materials for protective gloves include: Nitrile Rubber, Silver Shield, Viton.
Respiratory Protection: No respiratory protection is normally required.
Occupational Exposure Limits:
Component Agency TWA STEL Ceiling Notation
White Mineral Oil ACGIH 5 mg/m3 10 mg/m3 --- ---
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Attention: The data below are typical values and do not constitute a specification.
COLOR: Colorless
PHYSICAL STATE: Liquid
ODOR: Petroleum Odor
pH: Not applicable
VAPOR PRESSURE: <0.01 mmHg@ 37.8 °C (100 °F)
VAPOR DENSITY (AIR=1): >1
BOILING POINT > 260 °C (500 °F)
SOLUBILITY: Soluble in hydrocarbons; insoluble in water
FREEZING POINT Not applicable
MELTING POINT: Not available
SPECIFIC GRAVITY: 0.82 - 0.86 @ 15.6°C (60.1°F) / 15.6°C (60.1°F)
VISCOSITY: 7.5 cSt - 90 cSt @ 40°C (104°F) (Min)
COEFFICIENT OF WATER/OIL DISTRIBUTION: No Data Available
SECTION 10: STABILITY AND REACTIVITY
CHEMICAL STABILITY: This material is considered stable under normal ambient and anticipated storage and handling conditions of
temperature and pressure.
INCOMPATIBILITY WITH OTHER MATERIALS: May react with strong acids or strong oxidizers
HAZARDOUS DECOMPOSITION PRODUCTS: None known (None expected)
HAZARDOUS POLYMERIZATION: Hazardous polymerization will not occur.
SENSITIVITY TO MECHANICAL IMPACT: No
SECTION 11: TOXICOLOGICAL INFORMATION
IMMEDIATE HEALTH EFFECTS
Eye Irritation: The eye irritation hazard is based on evaluation of data for similar materials or product components.
Skin Irritation: The skin irritation hazard is based on evaluation of data for similar materials or product components.
Skin Sensitization: The skin sensitization hazard is based on evaluation of data for similar materials or product components.
Acute Dermal Toxicity: LD50: >5g/kg (rat). The acute dermal toxicity hazard is based on evaluation of data for similar materials or product
components.
Acute Oral Toxicity: LC50: >5000 mg/kg (rat) The acute oral toxicity hazard is based on evaluation of data for similar materials or product
components.
Acute Inhalation Toxicity: The acute inhalation toxicity hazard is based on evaluation of data for similar materials or product components.
For additional information on the acute toxicity of the components, call the technical information center.