MSDS

MATERIAL SAFETY DATA SHEET
Butcher Block & Cutting Board Oil MSDS DATE: 06/16/11
PAGE 1 OF 3
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: Butcher Block & Cutting Board Oil
MANUFACTURER: Howard Products, Inc.
ADDRESS: 560 Linne Road
Paso Robles, CA 93446
EMERGENCY PHONE: [phone]
CHEMTREC PHONE: [phone]
FAX PHONE: [phone]
PRODUCT USE: For oiling and moisturizing butcher blocks and cutting boards.
PREPARED BY: Justine Lopez
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
INGREDIENT(s): CAS # % VOL
White Mineral Oil 8042-47-5 100%weight
Di Alpha Tocopherol (Vitamin E) 59-02-9 <1%
SECTION 3: HAZARDOUS IDENTIFICATION
HAZARD DESIGNATION: Non-Hazardous According To the Criteria of NOHSC
SECTION 4: FIRST AID MEASURES
Eye Contact: Minimal eye irritation may result from short-term contact with liquid, mist, and/or vapor.
Skin Contact: No significant irritation is expected to occur upon short-term exposure.
Inhalation: No significant adverse health effects are expected to occur upon short-term exposure.
Ingestion: Ingestion can cause a laxative effect. If liquid material enters into the lungs, it can cause severe damage.
SECTION 5: FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES:
Flashpoint: (Cleveland Open Cup) 129 °C (265 °F)
Autoignition: No Data Available
Flammability (Explosive) Limits (% by volume in air): Lower: Not Applicable Upper: Not Applicable
EXTINGUISHING MEDIA: Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.
PROTECTION OF FIRE FIGHTERS:
Fire Fighting Instructions: This material will burn although it is not easily ignited. For fires involving this material, do not enter any enclosed
or confined fire space without proper protective equipment, including self-contained breathing apparatus.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Protective Measures: Eliminate all sources of ignition in vicinity of spilled material.
Spill Management: Stop the source of the release if you can do it without risk. Contain release to prevent further contamination of soil,
surface water or groundwater. Clean up spill as soon as possible, observing precautions in Exposure
Controls/Personal Protection. Use appropriate techniques such as applying non-combustible absorbent materials or
pumping. Where feasible and appropriate, remove contaminated soil. Place contaminated materials in disposable
containers and dispose of in a manner consistent with applicable regulations.
Reporting: Report spills to local authorities as appropriate or required.
SECTION 7: HANDLING AND STORAGE
HANDLING: Use good industrial hygiene practices in handling this material.
STORAGE: Keep out of reach of children. Store in a closed container away from incompatible materials.