Manual

21
DISASSEMBLY
First make sure the rifle is unloaded. Put safety "on".
1. To remove bolt from rifle (Fig. 10):
A. With the bolt part way to the rear, depress
the bolt stop and withdraw the bolt rearward
out of the receiver.
2. To remove stock:
A. Place firearm on a clean padded surface
which allows you to firmly grasp rifle. With a
well fitting screwdriver, loosen and remove the
takedown screw at the rear of the trigger
guard. Next loosen and remove the takedown
screw in front of the trigger guard.
B. Remove trigger guard and carefully separate
stock and action. Remove the magazine box
from the receiver.
WARNING!
1. Wear safety glasses to prevent eye injury in
case any part under spring tension escapes from
your grasp.
2. Do not tamper with the adjustment screws on
the trigger assembly. The screws have been
properly set and sealed at the factory. Any
attempt to reset the adjustment screws may
render the safety inoperative, and result in a
hazardous condition. If the seals on these
screws have been broken, return the gun
immediately to LSI for proper readjustment.