HoverCam.com HoverCam.
1.Powering On To first use the Ultra 10,you can plug the included power cord into an available power outlet ,and plug the other end of the cord into the Ultra 10 Type-c outlet . to power outlet When the battery is full, you can remove the power cord and power it directly through the battery Next ,press and hold the power button for five seconds . Boot-up time is approximately 60 seconds.
2.Connecting to Display To connect Ultra 10 with HDMI,simply insert an HDMI cable to the HDMI-Out port on the Ultra 10 and the display you wish to use .Make sure the HDMI Switch is set to “OUT”.
3.
Installation: Before use the DotCam RED, You need to install the “Flex 11".you can download the software on “ www.HoverCam.
10 10 HoverCam.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
