User's Manual

滑板车遥控器使用说明
H12N1-20191107
brake by roller.
Push “roller” forward to control scooter to go ahead. Pull “roller” backward to contorl scooter to brake.
Note: Do not push/pull “roller” when press “power” key.
6)
滑板方向切换
前进状态下，单击“Reverse”键切换前进方向至后退模式；
后退状态下，单击“Reverse”键切换前进方向至前进模式；
注：前进方向切换仅在时速低于 3km/h 时才有效。
6) Switch direction of scooter
In forward state, press “Reverse” key to switch from forward direction to backward mode;
In backward state, press “Reverse” key to switch from forward direction to forward mode;
Note: Forward direction only can be switched when the speed is less than3km/h.
04 故障警报说明: Malfunction warning instruction:
1) 电池低压警报
① 当遥控器电量低于 25%，遥控器电量指示灯闪烁。此时油门将无效，仅刹车有效，需尽快为遥控器充电。
②
当滑板电量低于 10%时，滑板电量指示灯单灯闪烁“○○☉”,并伴随每隔 1 秒短响 1 声的鸣音提示，电量过低油门将
无效，仅刹车有效，需尽快为滑板电池充电。
2) 信号丢失警报
若滑板正在进行加速操作，信号丢失时首先油门立即自动归零，然后自动缓慢刹车；若正在刹车，则缓慢上升或降到一个固
定的刹车力度。信号丢失后，遥控器将进入搜寻滑板设备状态，伴随信号指示灯常亮并每隔 1.5 秒 3 声短鸣音提示，搜到并
重新连接成功后指示灯及鸣音恢复正常，缓慢刹车取消，并且油门归零后滑板方可恢复正常操作。
3) 过热警报
当控制器温度过高时，动力输出减弱，直至温度恢复正常。
注：使用者应留意电调以及电机温度，当电调或电机温度运行偏高时，使用者应仔细检查原因，待原因排除后再使用。
4) 硬件故障警报
若自检硬件故障，控制器将发出每隔 4 秒 4 次的短鸣音，并停止动力输出。
5) 过流/堵转警报
保护触发时，控制器将发出单次循环短鸣，并切断动力输出，油门回到零点无故障时恢复输出。
1) Battery low-voltage warning
a)
If the battery of remote of control is less than 25%, the battery indicator of remote control flashes. Only brake is available,
need to charge remote control as soon as possible.
b) When the battery of scooter is less than 10%, a single battery indicator of scooter flashes “○○☉”, with a short sound every
second to warn. If the battery is too less, the throttle is unable and only the brake is available. Need to charge the scooter battery
as soon as possible.
2) Signal loss warining
The throttle will return to zero automatically when scooter loses the signal during accelerating, then brake slowly and
automatically. It will ascend or reduce to a fixed braking force during braking. The remote control will search for scooter
device after losing signal, with signal indicator is constantly on and three short sounds every 1.5 seconds to warn. The
indicator and sound will return to normal if succeed to search and reconnect. Cancel slow brake and return the throttle to zero
before normal operation.
3) Overheat warning
When the temperature of controller is too high, the power output will weaken until the temperature returns to normal.
Note: The users should keep an eye on the temperature of ESC and motor. When the operating temperature of ESC and motor is
too high, the users should check the cause and use it after troublshooting.
4) Hardware malfunction warning
If self-inspection hardware malfunction, the controller will make 4 short sounds every 4 seconds and stop power output.
5) Overcurrent /lock-up warning
If the protection triggered, the controller will make a single short sound circularly and cut off power output. The output will be
restored after the throttle returns to zero and has no malfunctions.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help
The device must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Remote of Stakeboard User Manual