Owner's Manual

CRUISE CONTROL
After H1-BSS power on, please confirm whether the cruise control indicator
flashes, if the cruise control indicator flashes, it means that the cruise function
has been turned on; if the cruise control indicator is not lit, it means that the
cruise function has been turned off.
The cruise function comes preset as active in your H1-BSS, to start up the cruise
mode you just need to press the Throttle down for 6 seconds and you will hear 2
beeps at the same time the cruise control indicator will light up on the LED
display indicating that it is activated.
To cancel the cruise mode, press the Throttle down once or squeeze the Brake
handle.
To activate or deactivate the cruise function you only need to click the power
button 4 times.
KICK TO START
For safety reasons, the E-Scooter will not accelerate unless it is already moving at
least 1.8 mph (3 km/h). You must first kick off the ground and then press the
throttle in order to ride the E-Scooter.
RIDING YOUR BOSS ESCOOTER
FAILURE TO FOLLOW ANY OF THE FOLLOWING SAFETY PRECAUTIONS
CAN LEAD TO DAMAGE TO YOUR DEVICE, VOID YOUR MANUFACTURER
WARRANTY, LEAD TO PROPERTY DAMAGE, CAUSE SERIOUS BODILY
INJURY, AND CAN LEAD TO DEATH.
OPERATING YOUR DEVICE
Do not turn sharply or at high speeds. Do not turn or ride quickly along slopes,
as it may cause injury. Proper use of your brake is vital to ensure safe, efficient
stopping. To avoid misuse and potential injury, do not apply sudden or
excessive force to your brake. Apply the brake gradually and give yourself
enough room to come to a complete stop safely.
WARNING
Make sure the device is fully charged before the first use. Before turning on your
Boss E-Scooter, ride it like a normal kick scooter to get comfortable with the device
before using it with the motor.
When you are comfortable riding the E-Scooter, power it on. For the motor to
activate, you must first start riding the E-Scooter manually and then push the
throttle down with your thumb.
To slow down, disengage the throttle and squeeze the brake handle to engage the
disk brake. The brake is pressure-sensitive, so a tighter squeeze will provide more
stopping power.
Use the handlebars to turn in the desired direction.
The Boss E-Scooter can be operated manually if you do not wish
to use the motor.
Quickly press the power button two times to turn the headlight on/off. Quickly
press the power button three times to switch units between KM/H and MPH.
Quickly press the power button six times to switch between the odometer and the
trip mileage.
At higher speeds, you may need to shift your weight to maintain your balance while
making turns.
Prepare to brace yourself if you encounter bumps or uneven surfaces, then
dismount and carry your Boss to a safe operating surface.
27 28