Installation Sheet

ManualsBrandsHOUZER ManualsKitchenEpicure Series Apron Front Stainless Steel 30 in. Single Bowl Kitchen Sink, Satin Brushed

Installation instructions for

Epicure series Farmhouse Sink

General Recommendations:

Please read installation and maintenance instructions thoroughly.

Inspect your sink for any noticeable damage before installation.

Check all local applicable plumbing and building codes.

These instructions are based on application to composite material or solid surface countertop installation only;

countertop application to stone, marble, granite or butcher-block should be referred to an experienced

countertop fabricator for custom installation.

Epicure series Farmhouse sinks are individually hand-crafted and HOUZER suggests using experienced and

professional installers only. For custom cutting of countertop and installation of the actual sink, on-site

installation is also recommended. Acceptable variances are approximately 1/8 of an inch. Alignment to

the cut-out and precise application and trimming of any adhesive sealant are critical to a superior fit and

finished look. Please take extra care in this regard.

Epicure series Farmhouse sinks require custom order cabinets. Consult your cabinet dealer.

HOUZER does not accept any liability for damage to countertop, sink fixture, faucets or personal injury

during installation. Warranty is void if installation instructions are not followed.

Tools and Materials needed:

Tape Measure

Framing Square

Eye Protection

Hacksaw/Jigsaw

Ear Protection

Silicone Adhesive Sealant

Rags

Shims

Wood Braces

Pencil (NOT ink)

Denatured Alcohol

Be sure to use proper tools and always wear personal safety devices for your protection.

Summary of content (4 pages)

PAGE 1
Installation instructions for Epicure series Farmhouse Sink General Recommendations: Please read installation and maintenance instructions thoroughly. Inspect your sink for any noticeable damage before installation. Check all local applicable plumbing and building codes.
PAGE 2
Installation Options: Epicure series Farmhouse sinks offer installation options depending on your design. Undermount Installation Flush mount Installation Built-up Installation Figure 2 Figure 3 Figure 1 Caution: All installation types need to allow room for faucet installation. Ensure adequate clearance behind the sink for any faucet and backsplash, as well as full range of motion for faucet spouts and handles. Typical undermount installation with 1/4" reveal recommended.
PAGE 3
1. Prepare the Sink Base Cabinet Farmhouse sinks require custom order sink base cabinets with a front cutout to accommodate a 10" deep sink. Build a plywood platform on a support frame inside of the sink base cabinet. Platform must support the weight of the sink and any attachments such as garbage disposals. When the sink is placed onto a platform, make sure the top of the sink is evenly flush against the bottom of the countertop.
PAGE 4
Care and Maintenance ALWAYS • Clean everyday by thoroughly rinsing with a mild soap and warm water and wipe dry. • Rub lightly with a soft cloth in the direction of grain lines on a regular basis for additional preventive cleaning. • Keep the sink free of any standing water as this can cause a buildup of mineral deposit, which can affect the appearance of your sink. • Any stubborn stains should be removed by scrubbing in the direction of the grain with a mild abrasive such as Comet.