Installation & Assembly

Step 3
Next, place the chair onto the side of a table as seen in Picture 1.
You will now have the chair bottom and all 4-legs facing skywards.
Insert each front leg completely vertically into each seat frame
corner.
PRESS FIRMLY DOWN with your hand until there is no gap.
WARNING!! DO NOT POSITION THE FRONT WOODEN LEG AS
SHOWN IN PICTURE 2 .
THIS PICTURE SHOWS THE CHAIR BACK STAYS AGAINST
THE GROUND and THE FRONT LEGS HORIZONTAL IN MIDAIR.
Now tighten the bottom bolt at first, then the blot on the top by using
4 Bolts(①)+4 Flat washer Rings(②)+4 Spring washer Rings (③)
with your hands.
DOT NOT tighten the top bolt first.
WARNING!! DO NOT OVER TIGHTEN. OVER TIGHTENING
COULD LEAD TO DAMAGING THE PRODUCT. TIGHTEN ONLY
UNTIL SECURE AND STABLE.
3
1
2
Page 5 of 7