Installation & Assembly

Step 1

Step 2

Place the chair back (A) on a soft surface to avoid any scratches on

the products.

Take out the 2 wooden legs and the package of hardware

accessories.

Put the chair back( A) onto a flat table or panel.

Insert the positioning dowels on the chair seat back panel (B) to the

positioning holes on the chair back panel(A).

Align the holes on chair back(A) to the holes on chair seat frame.

Use your left hand to push the seat frame floorwards, depicted by

Arrow 1.

This action helps to ensure the chair seat(B) is pressed towards to

the chair back(A) with no gap between these.

Then, lock the middle hole and the corner holes.

The hardware for these are : use 5 Bolts (①)+ 5 Flat Washer Rings

(②) + 5 Spring Washer Rings (③) with the Allen key(④).

At this point of assembly, DO NOT overfasten the connections.

Page 4 of 7