Installation Instructions

MOUNT CROSSBAR AND CONNECT THE

WIRES

If there is an existing fixture remove it. Expose the supply

wires from the J-box. Install the crossbar plate and mount

it to the J-Box with the supplied screws. Gently pull the supply

wires through the hole in the crossbar plate. Connect the

black supply wire to the black fixture wire. Secure with the

supplied wire nuts. Connect the white supply wire to the white

fixture wire. Secure with the supplied wire nuts. Attach the

green J-Box wire around green hexagonal head screw or

connect it to the green supply grounding wire of the fixture.

Secure all wires with electrical tape (not supplied).

Tuck all wires carefully into the J-Box.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

MOUNT THE FIXTURE

Place the backplate to the the crossbar.

Align the holes at the top and the bottom of backplate and

secure with the supplied screws.

INSTALL THE CRYSTAL SHADES

Place the crystal shades up to the fixture and fitting

over the LED module. Secure with the supplied socket rings.

If the fixture is to be removed or replaced,

please ensure that the electricity is

switched off and that the fitting is cool

before touching it.

CAUTION

CERTIFICATION: cETLus DAMP

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEW FIXTURE

Dimmable xture - see attached list for compatible dimmer switches.