Installation Guide

Once cut, remove the balusters by slowly

pushing them back and forth until the nails are

worked loose.

Remove the existing nails from the rail and base

using pliers and apply wood ller to the nail

holes if necessary.

Now is a good time to layout your new iron

balusters against the rail to make sure your

pattern and spacing are correct.

Once proper spacing (refer to your local building code)

has been established, mark your rail and cap with a

pencil where you will drill your holes according to the

diameter of your baluster. Drill 1/4 inch deep into the

cap and 1-1/2 inch deep into your handrail. This will

allow you to slide the baluster up into the

handrail and drop down into the cap.