Installation Guide

(J) Measure distance between inside corner block (#3) and pencil line.
(K) Cut base moulding to this length using straight cuts. Drill holes in base and plinth.
(L) Push base moulding (#4) tight against inside corner. Nail base in place starting at inside corner and moving
toward plinth block. Push plinth tight against base; nail in place.
(M) Continue this same procedure around room until complete.
(N) Fill nail holes and any gaps with putty or wood filler of matching color (use smallest amount possible for a neat
job). Then carefully touch up with paint or stain, only where necessary.
Important:
Be sure to use a smooth-face finishing hammer to drive nails.
Do not pound nails in all the way with hammer alone — use a nail set for the last 1/8”, counter sink nail head 1/16” so
that wood filler can be applied later to hide nail head.