Installation Guide

(E)Place inside corner block tightly in corner (see #3 in illustration at top of page). Measure the distance from the
outside corner to the inside corner (see #1 and #3 in illustration at top of page).
(F) Cut piece of base moulding (#2) to this length. Use simple straight cuts.
(G) Drill 3/32” holes in base moulding and inside corner block.
(H) Position base moulding and inside corner in place. Push base tightly against outside corner (see #1 and #2 in
illustration at top of page). Nail base moulding in place with finish nails, starting at outside corner and moving toward
inside corner. Push inside corner tightly against base moulding (see #3 in illustration above). Nail in place.
(I) Position plinth block at base of door jamb (see #5 in illustration at top of page). Set plinth block approximately
1/8” back from jamb. Mark wall with pencil line on left side of plinth.