User's Manual

Mechanical installation
30 A4429-1.0 HBM: public T40FH
Important
To avoid axial oscillation, a clamp fixture is enclosed with
the torque transducer to enable the antenna ring to be
supported. There is a hole, 6.5 mm in diameter, on the
upper antenna segment to receive the clamping device
(see Fig. 5.7).
The cable plug (not included in the scope of supply) also
requires support in this case; a construction example is
shown in Fig. 5.9.
Fig. 5.7 Construction example for supporting the antenna
ring