User's Manual
Table Of Contents
- T40FH
- T40FH
- English
- 1 Safety instructions
- 2 Markings used
- 3 Application
- 4 Structure and mode of operation
- 5 Mechanical installation
- 6 Electrical connection
- 7 TEDS transducer identification (Option 3, Code PNJ)
- 8 Shunt signal
- 9 Functionality testing
- 10 Load-carrying capacity
- 11 Maintenance
- 12 Waste disposal and environmental protection
- 13 Dimensions
- 14 Ordering numbers, accessories
- 15 Specifications
- 16 Supplementary technical information
- English
- T40FH
- Deutsch
- 1 Sicherheitshinweise
- 2 Verwendete Kennzeichnungen
- 3 Anwendung
- 4 Aufbau und Wirkungsweise
- 5 Mechanischer Einbau
- 6 Elektrischer Anschluss
- 7 Aufnehmer‐Identifikation TEDS (Option 3, Code PNJ)
- 8 Shuntsignal
- 9 Funktionsprüfung
- 10 Belastbarkeit
- 11 Wartung
- 12 Entsorgung und Umweltschutz
- 13 Abmessungen
- 14 Bestellnummern, Zubehör
- 15 Technische Daten
- 16 Ergänzende technische Informationen
- Deutsch
Mechanical installation
28 A4429-1.0 HBM: public T40FH
Ø 6.5 mm hole for fixing
the antenna segment
Stator housing
upper
Antenna segment
screws with washers
(M4+M5)
lower
Antenna segments
Antenna segment
screws with washers
(M4+M5)
Fig. 5.6 Bolted connection of the antenna segments on the
stator
1. Undo and remove both the bolted connections
(M4+M5) on the upper antenna segment.
There are fan-type lock washers (M4+M5) between
the antenna segments: make sure that they do not get
lost.
2. Use an appropriate mounting base to install the stator
housing in the shaft train, so that there is sufficient
opportunity for horizontal and vertical adjustments. Do
not fully tighten the screws yet.
3. Now use four hexagon socket screws to mount the
upper antenna segment removed in Point 1 on the
lower antenna segment.