User Manual
Table Of Contents
- Introduction
- Service Centre
- Intended use
- Package content
- Technical data
- Symbols explication
- Safety notes
- Installation
- Binding
- Interfaces
- Programming the receiver settings
- Programming a fixed-wing model
- Gyro assignment
- Programming the regulation
- Initialization of the gyro
- Adjust servolimit for channels
- Programming a helicopter model
- Basic settings
- Axis assignment
- Swashplate setting without Expertmode
- Swashplate setting with Expertmode
- Tail rotor setting without Expertmode
- Tail rotor setting with Expertmode
- Firmware update
- Declaration of conformity
- Notes on environmental protection
- Care and maintenance
- Warranty
8 / 36
S1034_Falcon_12_plus
Installation
Fixed-wing model
The receiver must be aligned at right angles to the model on the
receiver platform.
The lower surface of the receiver must always be parallel to one of
the model sides.
Prior to installation, remove the sticker on the back of the receiver.
We recommend using double-sided tape No.: S8376 for Gr-18 to fix
the receiver in place. Also the so-called mirror adhesive tape is suit-
able.
Helicopter model
The receiver must be aligned at right angles to the helicopter on the
receiver platform. Prior to installation, remove the sticker on the
back of the receiver. We recommend using double-sided tape (No.
S8376 for Gr-18) to fix the receiver in place. The receiver must be
connected to a stable power supply with at least two power cables.
Comply with the maximum power consumption permitted by the
servos. All connections can be used for this purpose.
OK
This installaon posion is at the moment not yet relevant,
but in case of later use of the accelerometers (through so-
ware update) it will be important!
OK