User Manual
Table Of Contents
- Introduction
- Service Centre
- Intended use
- Package content
- Technical data
- Symbols explication
- Safety notes
- Installation
- Binding
- Interfaces
- Programming the receiver settings
- Programming a fixed-wing model
- Gyro assignment
- Programming the regulation
- Initialization of the gyro
- Adjust servolimit for channels
- Programming a helicopter model
- Basic settings
- Axis assignment
- Swashplate setting without Expertmode
- Swashplate setting with Expertmode
- Tail rotor setting without Expertmode
- Tail rotor setting with Expertmode
- Firmware update
- Declaration of conformity
- Notes on environmental protection
- Care and maintenance
- Warranty
5 / 36
S1034_Falcon_12_plus
Intended use
More punctual information about receiver can be found in the Tech-
nical data section.
The receiver is designed exclusively to be used in battery-powered,
radio controlled models, any other use is not allowed. For any
improper use no warranty or liability is accepted.
Read through this entire manual before you attempt to install or use
the receiver.
Graupner/SJ constantly works on the development of all products;
we reserve the right to change the item, its technology and equip-
ment.
Target group
The product is not a toy. It is not suitable for children under 14 years.
The installation and operation of the receiver must be performed by
experienced RC models enthusiasts. If you do not have sufficient
knowledge about dealing with radio-controlled models, please con-
tact an experienced model builder or a model club.
Package content
Falcon 12 plus HoTT 2.4 GHz 3 axis gyro receiver
Manual
Technical data
Falcon 12 plus
Temperature range - 15...+70 °C
Antenna length 2 x wire 145 mm
Total weight approx.: 9 g
Frequency 2400 ... 2483.5 MHz
Range approx. 4000 m
Dimensions approx. 36 x 21 x 10 mm
Modulation 2.4 GHz FHSS
Power
consumption
70 mA
Operating voltage 3,6 ... 8,4 V