User Manual
Table Of Contents
- Introduction
- Service Centre
- Intended use
- Package content
- Technical data
- Symbols explication
- Safety notes
- Installation
- Binding
- Interfaces
- Programming the receiver settings
- Programming a fixed-wing model
- Gyro assignment
- Programming the regulation
- Initialization of the gyro
- Adjust servolimit for channels
- Programming a helicopter model
- Basic settings
- Axis assignment
- Swashplate setting without Expertmode
- Swashplate setting with Expertmode
- Tail rotor setting without Expertmode
- Tail rotor setting with Expertmode
- Firmware update
- Declaration of conformity
- Notes on environmental protection
- Care and maintenance
- Warranty
31 / 36
S1034_Falcon_12_plus
Tail dynamic
10 -100, default setting: 65
Higher dynamic values provide a more direct control feeling, lower
values result in a smoother control feel. If the values are too high,
the tail does not stop and it can overflow. If the values are too low,
the control behavior becomes softer.
Vibration damping
YES-NO, default setting: NO
The vibration damping automatically detects emerging vibrations at
the tail rotor, e.g. at extreme speed flights (wind flag effect) or strong
speed changes in some 3D maneuvers (over-speed) and prevents an
extremely strong swing-up. The tail rotor should be set free of vibra-
tions without active vibration damping in 3D and normal flight situ-
ations, only with a solid basic setting it makes sense to activate the
vibration damping.
Stop damping R / Stop damping L
0 -20, default setting: 5
The rear stop parameter on the right and left optimizes the stop
behavior after a yaw movement. The tail should stop as quickly as
possible without moving back. Select the value so low that the tail
does not move back at when stopping. The higher the value, the
more the stop is dampened. Determine the value in steps of 1.