User Manual

25 / 36
S1034_Falcon_12_plus
Axis assignment
DO SETUP
DO SETUP: Yes/No
Assignment of the gyros and their operating direction.
If you have not already done so, you must now set the C1-4 servo
directions so that everything works correctly.
In the receiver's "Axis assign" menu, go to the "Setup" option and set
it to "Setup: Yes". Now assign the axes as follows:
On the transmitter, briefly set the roll command fully to the right; the
roll axis is highlighted. You will then have both hands free again to
operate the helicopter.
Roll the helicopter more than 45° to the right → the identified axis
with the required prefix is displayed, the field is no longer highlighted
and identification of this axis is complete
Now do the same for nick: on the transmitter, briefly set the nick
command so that it is fully forward.
Roll the helicopter more than 45° forwards; the axis is displayed, the
field is no longer highlighted and identification of this axis is com-
plete
Finally complete the procedure for the tail: on the transmitter, briefly
set the tail command fully to the right
Turn the helicopter so that the nose turns more than 45° to the right;
the axis is displayed, the field is no longer highlighted and identifica-
tion of this axis is complete.
The assignment of the axis assignment automatically adjusts the pir-
ouette optimization. If the tail servo direction is subsequently
changed, the axis assignment must be performed again.
The gyros and operating directions have now been assigned. Now
check to make sure that the operating directions are correct. See the
illustrations below.
Axis assignment <
>DO SETUP: Yes
Roll (right): +2
>Nick (push) +0
>Tail: (right +0
Axis assignment <
>DO SETUP No
Roll (right): +2
Nick: (push): +1
>Tail (right): -3