User Manual
Table Of Contents
- Introduction
- Service Centre
- Intended use
- Package content
- Technical data
- Symbols explication
- Safety notes
- Installation
- Binding
- Interfaces
- Programming the receiver settings
- Programming a fixed-wing model
- Gyro assignment
- Programming the regulation
- Initialization of the gyro
- Adjust servolimit for channels
- Programming a helicopter model
- Basic settings
- Axis assignment
- Swashplate setting without Expertmode
- Swashplate setting with Expertmode
- Tail rotor setting without Expertmode
- Tail rotor setting with Expertmode
- Firmware update
- Declaration of conformity
- Notes on environmental protection
- Care and maintenance
- Warranty
21 / 36
S1034_Falcon_12_plus
Basic settings
Procedure
1. Once the transmitter and helicopter have successfully been pre-
pared, call up the Telemetry menu in the transmitter (see trans-
mitter instructions).
2. Set in the receiver the model type "Hely" (see section "Receiver
settings"). Then change to the menu "Base setup contr.".
3. Scroll past the swashplate/tail setup menus; these will be used
later on.
4. You must work through each item of this menu in order
from top to bottom:
Base setup controller
When a value is activated in the basic setting control, the gyro con-
trol and partly the control are deactivated! Therefore, settings must
not be carried out in the air, but must be carried out on the ground
without speed!
Rotation direction
Here you can set the direction of the rotor rotation, seen from above
the helicopter. Right or left
Swp type
Swashplate type: select the correct swashplate type. 90°, 120°, 135°,
140°.
Default setting 120°
BASE SETUP CONTR.<v>
>Rotating dir right
Swp Type 120 deg.
Swp Frequency 200Hz
Swp direction +0
Swp Roll Trim +0
Swp Nick Trim +0
Swp Pitch Trim +0
Swp travel 8d +80
Collective_B +80
Cyclic max +80
Swp rotate +0
Tail servo 1.5ms
Tail frequency 333Hz
Tail mid +0
Tail limit B +50
Logging +3
Expertmode No