User Manual
Table Of Contents
- Introduction
- Service Centre
- Intended use
- Package content
- Technical data
- Symbols explication
- Safety notes
- Installation
- Binding
- Interfaces
- Programming the receiver settings
- Programming a fixed-wing model
- Gyro assignment
- Programming the regulation
- Initialization of the gyro
- Adjust servolimit for channels
- Programming a helicopter model
- Basic settings
- Axis assignment
- Swashplate setting without Expertmode
- Swashplate setting with Expertmode
- Tail rotor setting without Expertmode
- Tail rotor setting with Expertmode
- Firmware update
- Declaration of conformity
- Notes on environmental protection
- Care and maintenance
- Warranty
16 / 36
S1034_Falcon_12_plus
Note
Before you start entering settings for a new model, it is essential to
select the number of aileron servos in the Aileron servos menu
point, and to define the gyro axes and orientation in the New set-
tings menu point.
Programming the regulation
Gyro setting display
MODE
In this point you can select the gyro correction mode (0-3):
0 - no gyro correction
1 - normal gyro correction (P and D parameter)
2 - heading lock mode (I parameter) with suppression
(Outside the suppression area the gyro control is active, in stick
center position acts the heading lock)
3 - Rate mode
(Heading lock acts in stick center position through the entire area)
Note
In Heading lock mode the servos are moved to the center position
if the factor is set to 0%.
Mode switching
The mode can be set separately for AILE/ELEV and RUDD. The mode
can be set permanently or it can be switched through an assigned
channel. Program the selected channel in your transmitter with a
switch, the following positions switch the related mode:
Mode 0 - 100%
Mode 1 - 50%
Mode 2 0%
Mode 3 ≥ 50%
Preparation step by step:
1. Trim the model with the gyro correction off
2. Switch the receiver off and on to save the values as standard
3. Activate the gyro correction
4. The phase trim should not be used!
5. Set the factor for gyro correction, eventually check the values for
the single control surfaces
GYRO SETTINGS< >
MODE AIL/ELE (2)CH7
MODE RUDD (2)CH7
>Aileron: 0
>Elevator: 0
Rudder : 0
Factor : (44%)C10