User Manual
Table Of Contents
- Introduction
- Service Centre
- Intended use
- Package content
- Technical data
- Symbols explication
- Safety notes
- Installation
- Binding
- Interfaces
- Programming the receiver settings
- Programming a fixed-wing model
- Gyro assignment
- Programming the regulation
- Initialization of the gyro
- Adjust servolimit for channels
- Programming a helicopter model
- Basic settings
- Axis assignment
- Swashplate setting without Expertmode
- Swashplate setting with Expertmode
- Tail rotor setting without Expertmode
- Tail rotor setting with Expertmode
- Firmware update
- Declaration of conformity
- Notes on environmental protection
- Care and maintenance
- Warranty
15 / 36
S1034_Falcon_12_plus
Elevator
Movement of the model Control surface action (tail view)
Rudder
Movement of the model Control surface action (tail view)
Aileron
Movement of the model Control surface action (tail view)
!
CAUTION
Check that all the gyros are
working in the correct
direction!
Move the model in all axes
directions. Check the move-
ments and travels.
Now check the control
surface deflections - see
diagrams below.
You must not fly the model
before doing this: crash
hazard!