Instructions / Assembly

14
ASSEMBLY INSTRUCTIONS
OPERATION
Step 14
Turn the cylinder valve on the tank clockwise to close
the propane tank. Attach the preassembled regulator to
the cylinder valve by turning the regulator coupling nut
clockwise. Make sure it is fastened securely and tighten
connections by hand only.
Before performing a leak test, be sure that no sparks can occur, and you are in a spacious outdoor area. Connect
the propane gas tank to the regulator and turn the valve on the unit to the “off” position. Brush a soap and water
mixture on all connections. Turn the gas supply on; if bubbles appear on any connection there may be a leak. If you
smell gas or a leak is discovered turn the gas valve off, disconnect the propane gas tank and do not use the appli-
ance until the leak is repaired.
1. The glass tube may break if it is wet while in use; never use the heater while it’s raining outside.
2. Do not splash any liquid on the heater while it is in use.
3. Keep children away from the unit while in use; the glass tube may be extremely hot while in use. Do not touch.
4. Ensure that the heater is on a strong and flat surface. The heater may be damaged if the unit tips over.
5. Never use the heater is the glass tube shows any cracks.
REGULATOR
BLACK COUPLING NUT
CYLINDER VALVE
PRESSURE
BLEED-OFF
VALVE
turn clockwise
to reseal
turn clockwise to connect
RELIEF VALVE
RUBBER O-RING
WARNING:
Please inspect the rubber O-ring in the propane tank valve to
ensure it is not worn before attaching regulator. Worn rubber
O-rings can cause leaks, explosions and serious injury by
propane tank.