Proline TDC75 CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS PAGE 4 ELECTRICAL CONNECTION PAGE 5 SAFETY ADVICES AND GENERAL RECOMMENDATIONS PAGE 6 DESCRIPTION OF THE DRYER PAGE 7 DOOR REVERSIBILITY / CHILD SAFETY LOCK PAGE 8 HEAT EXCHANGER PAGE
SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Please contact 0870 5425425. • Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous. • Remove the protective foil from the control panel. 2.
ELECTRICAL CONNECTION For your safety please read the following information Warning: This appliance must be earthed. The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin socket, suitably earthed and should be protected by a 13 amp fuse in the plug or a15 amp fuse in the consumer unit. The appliance is supplied with a moulded 13 amp 3 pin mains plug fitted with a 13 amp fuse.
SAFETY ADVICES AND GENERAL RECOMMENDATIONS 1. Packing 2. • • • • • • • • 3. • 4. 5. • • • • • • • • 6 The packing box may be fully recycled as confirmed by the recycling symbol . Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle.
DESCRIPTION OF THE DRYER A. B. C. D. E. F. G. H. Work top. Water Container Contact pin Door: To open the door: pull the handle. To close the door: push gently until closed. Filter Child Safety Lock Button for heat exchanger flap opening Heat exchanger A C F E D G H B Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle.
DOOR REVERSIBILITY / CHILD SAFETY LOCK Door Reversibility C A. Unplug the dryer. B. Open the door. C. Using a spanner, turn the contact pin in the upper part of the door by 90° and remove it. D. Unscrew the 2 screws of the door hinge and remove the door. E. Removing the door lock: Unscrew the 2 screws above and below the door lock system. Lift the door lock from the bottom, sliding it upwards about 1.5 cm, and remove it. F. Reverse the door: Fasten the door on the desired side with the 2 screws. G.
HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every month, proceeding as follows: A A. Open the door and press the heat exchanger flap button on the bottom of the door entrance. B. The heat exchanger flap opens. C. Fold the heat exchanger handle upwards to the horizontal position and remove the heat exchanger. D. Clean the heat exchanger under running water by turning it around to reach all sides. E.
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide After-Sales Service If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: If there is anything about the installation or operation of this product you do not understand, please contact our dedicated Helpline on 0113 2793520.
