Installation guide

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
] Tilt and tile blower unit back into tile
place
oi)ening, in tile top of tile microwave.
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
[]Secure tile blower unit to tile microwaxe with
tile two screws remoxed in Step 2.
Retaining
screw
Retaining
screw
[]Close tile blower cover and secure it with tile
screw remoxed in Step 1.
MOUNT THE MICROWAVE OVEN
FOIl EASIER INSTAI,IATION AND PERSONAl,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If yore" cabinet is metal, use tile nylon
grommet around tile power cord hole to prevent
cutting of the cord,
NOTE: We recommend using filler blocks if the
cabinet fl'ont hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
NOTE: When mounting
tile ii/icrowave oven,
thread power cord
through hole in bottom of
top cabinet. Kee I) it tight
throughout Steps 1-3. Do
not pinch cord or lilt
oven by pulling
_ I,ift microwave, tilt
it fl_rward and hook
slots at back bottom
edge onto four lower
tabs of motmting
l
_ Rotate front of o_,en
up against cabinet
bottoin.
_lnsert a sell:aligning screw through top center
cabinet hole. Temporarily secm'e the oven by
turning tile screw at least two full turns after tile
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
CabinetFront
CabinetBottomShelf
FillerBlock
i_oEquivalent to Depth
f CabinetRecess
Self-AligningScrew
MicrowaveOvenTop
21