Installation Instructions and Manual
49-5000041 Rev. 3
USING THE AIR CONDITIONER
Dip Switch Configuration
REMOVING THE FRONT PANEL
Dip switches controls are located behind front panel,
through an opening below the control panel. To
access,remove front panel.
Dip switches are accessible without opening the
control box.
8QLWPXVWEHSRZHUHG2))WRHIIHFWLYHO\FKDQJHWKHLU
status.
1. 3XOORXWDWWKH
bottom to release
it from the tabs .
2. Then lift up
UP(ON)
DOWN(OFF)
1 2 3 4 1 2 3 4
S1
S
2
S3
S4
S5
S6
S7
S8
S9
X
A0-
A3
Wall thermostat type
Heating type
Temperature display type
Control type
Setpoint limit 1
Setpoint limit 2
Fan CON/CYC for cooling
Fan CON/CYC for heating
1 2 1 2 3 4
Low temp. Protection
'LS6ZLWFKHV
DIP SWITCHES CONFIGURATIONS
6HHWKHWDEOHDQGILJXUHEHORZIRU'LS6ZLWFK
configurations and functions of each dip switch position.
No. UP (ON) DOWN (OFF) Remarks
6 (OHFWULF+HDW2QO\ (OHFWULF+HDWDQG3XPS+HDW )RU+HDW3XPSXQLWRQO\
6 7HPSHUDWXUH'LVSOD\LQ) 7HPSHUDWXUH'LVSOD\LQ&
6 :DOO7KHUPRVWDW(QDEOH &RQWURO3DQHO(QDEOH
66
6Ÿ6Ÿ))
6Ÿ6ź))
6ź6Ÿ))
6ź6ź))
7ZRFRQILJXUDWLRQV66FRPELQH
to select set point range.
6 )DQ&RQWLQXRXV5XQIRU+HDWLQJ )DQ&\FOHIRU+HDWLQJ
6 Fan Continuous Run for Cooling Fan Cycle for Cooling
6 /RZWHPS3URWHFWLRQHQDEOH /RZWHPS3URWHFWLRQGLVDEOH Optional
6
8VHVRPHW\SHVRIZDOO7KHUPRVWDW 8VH37$&RWKHU:DOO7KHUPRVWDW You can consult with the sales agency
or manufacturer for details
DIP SWITCH CONFIGURATION TABLE
NOTE: On heating mode, the setting temperature can
QRWEHKLJKHUWKDQ)
Wall Thermostat Enable
$ZLUHGZDOOWKHUPRVWDWFDQEHFRQQHFWHGWRWKHXQLW,ILW
LVWKLVGLSVZLWFKPXVWEHPRYHGWRWKH:DOO7KHUPRVWDW
(QDEOH3RVLWLRQ83EHIRUHWKHZDOOWKHUPRVWDWZLOO
control the unit.
Low temp. Protection (optional)
,IXQLWVHQVHVDURRPWHPSHUDWXUHEHORZ)WKHIDQ
motor and electric strip heat will turn on and warm
WKHURRPWR)7KHIDQVWRSVDVKRUWWLPHDIWHUWKH
temperature is satisfied.
Electric Heat Only (for heat pump unit only)
7KLVVHWWLQJLVW\SLFDOO\XVHGIRU(PHUJHQF\+HDWLQJ
Heat and Cool Fan CON/CYC Dip-switches
$OORZVWKHIDQWRRSHUDWHLQFRQWLQXRXVRUF\FOHPRGHV
while the unit is in heating and cooling mode.
CON(Continuous)
$OORZVIDQWRUXQFRQWLQXRXVO\FLUFXODWLQJDLUHYHQ
when the temperature setting has been satisfied. This
switch helps to maintain the room temperature closer
to the thermostat setting.
CYC(Cycle)
This setting allows the fan to cycle on and off with the
compressor or electric heater. The fan stops a short
time after the temperature setting is satisfied.
Setpoint Temperature Limits
3URYLGHVDUHVWULFWHGUDQJHRIWHPSHUDWXUHFRQWURO










