Instruction for Use

N C

M Y

INSTALLATION

REPLACING BURNER NOZZLES

Lift the cover to replace the nozzles; then proceed as follows:

1. Lift cover C and remove.

2. Loosen hinge screws B.

3. Remove the rack and burners from the hob.

4. Pullthehobforwardandthenliftuptoreleaseit(arrowD).

5. Keep the hob raised using a prop.

How to replace the burner nozzles

1. Loosen screw M of each nozzle support and completely lift air ring

2. Use a 7 mm box wrench to unscrew nozzle J and replace it by an

appropriate nozzle type according to the nozzle table.

ADJUSTING THE AIR SUPPLY

1. Use a gauge to adjust gap A between ring and nozzle J as shown in

the picture.

2. Retighten screw M.

ADJUSTING THE THERMAL LOAD AT REDUCED

FUEL FLOW RATE

1. Light the burner and set the knob to “small flame”.Removethe

knob.

2. Insert the blade of a fine screwdriver into the barrel and turn the

screwdriver to right or left until the gas flow rate is correct.

3. This adjustment is only possible for natural gas. If the cooker uses

bottled gas such as propane or butane, tighten the screw

completely.

MAINTENANCE

Disconnect the cooker before any and all maintenance operations.