User Manual

Customizing Your Ampero One
About
About will show you information about Ampero’s firmware.
Factory Reset
Use this menu to perform a factory reset. Remember, resetting Ampero
One will delete all of your saved changes and personal settings. Once
it is executed, it cannot be undone, so please back up your settings
before performing a factory reset.
After pressing Factory Reset, this display will come up with a warning.
When the factory reset is complete, this message
will appear. Press OK to return to the main menu.
EXP 2/FS
You can also connect external footswitches to EXP2/FS jack for
further control. This menu allows you to set up the working mode of
EXP 2/FS jack and the functions of external footswitches.
The menu includes MODE, FS4 TAP, FS5 TAP, BANK SEL MODE.
Select a mode from EXP (connect to expression pedal), Single FS
(single footswitch controller) and Dual FS (dual footswitch controller).
The MODE selection affects available options in this menu:
EXP: all other options are unavailable
Single FS: FS5 TAP is unavailable
Dual FS: all other options are available
FS4 TAP and FS5 TAP can be set up as follows:
Loop Rec/Play: Record/play loop phrases
Loop Stop: Stops looper playback
Looper Menu: Enter/exit looper menu
Drum On/Off: Drum rhythm play/stop
Drum Menu: Enter/exit drum menu
Tuner: Enter/exit tuner
Tap Tempo: Tap tempo function
Patch+/Patch-: Change patches by toggling up or down
Bank+/Bank-: Change banks by toggling up or down
EXP1 On/Off: Switching built-in expression pedal on/off
You can select Ampero One’s bank select mode when using external
footswitches as a bank switcher. This works for external
footswitches only.
Bank Sel Mode lets you select from two modes: Initial and Wait.
In Initial mode, Ampero One will jump to a new patch immediately
after switching a bank.
In Wait mode, when switching banks, the patch you’re using won’t be
changed (footswitch LEDs on Ampero One will keep flashing) until
you tap a footswitch again to confirm your selection.
DES I GN I NSP I RAT I O N
This display will come up with a warning.
Pressing YES will perform the factory reset. Pressing NO will return to
the previous menu. After continuing with the factory preset, this screen
will appear showing that reset is in progress. Do not disconnect the
power supply while the reset is in progress. Disconnecting the power
supply may cause Ampero One to malfunction.
16
Display
Use this menu to customize your Ampero One’s themes, languages,
etc.
Use DISPLAY MODE to switch two display modes in Main Display
screen. Mode 1 stresses patch number, and Mode 2 stresses patch
name. Default is set to Mode 1.
Use LANGUAGE to switch system language between Chinese and
English.
Use COLOR to switch between 7 theme colors.
About
About will show you information about Ampero One’s firmware.