User Manual
Table Of Contents
- 页 1
- 页 2
- 页 3
- 页 4
- 页 5
- 页 6
- 页 7
- 页 8
- 页 9
- 页 10
- 页 11
- 页 12
- 页 13
- 页 14
- 页 15
- 页 16
- 页 17
- 页 18
- 页 19
- 页 20
- 页 21
- 页 22
- 页 23
- 页 24
- 页 25
- 页 26
- 页 27
- 页 28
- 页 29
- 页 30
- 页 31
- 页 32
- 页 33
- 页 34
- 页 35
- 页 36
- 页 37
- 页 38
- 页 39
- 页 40
- 页 41
- 页 42
- 页 43
- 页 44
- 页 45
- 页 46
- 页 47
- 页 48
- 页 49
- 页 50
- 页 51
- 页 52
- 页 53
- 页 54
- 页 55
- 页 56
- 页 57
- 页 58
- 页 59
- 页 60
- 页 61
- 页 62
- 页 63
- 页 64
- 页 65
- 页 66
- 页 67
- 页 68
- 页 69
- 页 70
- 页 71
- 页 72
- 页 73
- 页 74
- 页 75
- 页 76
- 页 77
- 页 78
- 页 79
- 页 80
- 页 81
- 页 82
- 页 83
- 页 84
- 页 85
- 页 86
DESIG N IN SP IRATION
Customizing Your Ampero
22
The effect the current module is using will show up in the center of the
selection panel. If the current module is off, the effects name will be grayed
out.
Use quick access knob 3 to select the parameter you want to control. The
controllable parameters will vary with the different modules and effects.
Refer to Effects List for more on the controllable parameters of different
modules and effects. See page 40.
You can press any parameter on the selection panel of the main menu as a
quick access knob control target. This must be done on the touch screen, as
shown below:
Quick Access Knobs
This menu allows you to set the parameter targets for the three Quick
Access Knobs under the current patch. The parameter targets can also be
the effects parameters of the current effects module, patch volume and
patch tempo.
Use quick access knob 1 to select the target module. If you don’t want the
quick access knob on, select OFF to turn its function off. When a quick
access knob is off, the parameter panel will display the status as shown: